The Ultimate Guide To Window Tinting

0
2
vehicle wraps in market harborough

Window tints look simply amazing when done perfectly well. So if you’re considering getting your window tinted, take some time to thoroughly read through the guide below to ensure that you go on about it properly while keeping the whole process quality intensive.

In this piece, we have included aspects that are most relevant to window tinting so read along to find out more about it.

Read up on the law surrounding window tints

This is hands down the most important aspect that you should pay heed to before you go ahead with your plan. As a general rule of thumb, the front section of your window must allow 70% of the light to pass through whereas the rear windows can be tinted in any shade of your preference.

It could be as dark as you feel it should be. Before you further your ideas, it will be best if you look through gov.co.uk to gain access to the complete list of window tinting laws and rules.

How to begin the tinting process?

The Preparation

Once you have all the relevant materials and equipment in place, getting started with window tinting is a relatively easy process. Here’s what you will need to start:

Spray bottle

Window tint kit (pre-cut)

Tint solution mixture (2 to 3 drops of washing up liquid mixed with water)

Squeegee

Bucket

Cutting knife

Before you carry out any work with respect to your car, keep in mind that it will turn out to be as good as the time you spent on making it happen.

So if you do not make preparations and arrangement beforehand and just end up slathering the window tint vinyl directly on the surface instead of cleaning it first, the end result will turn out to be waste.

The Cleaning

Since that’s where the tint will be applied, it is obvious that the surface of the window has to be cleaned thoroughly with a squeegee, tint solution and microfibre cloth. Dip the cloth in the solution and continue cleaning the window till the cloth glides smoothly across the glass of the window without being interrupted by debris and other particles.

You have to make sure that you clean all the corners and edges thoroughly. Ensure that both the sides of the window are squeaky clean so that not even a bit of dirt is transferred when it is shut down.

The Installation Process

Apply the film against the exterior of the window to get an understanding of the sizing and to see if it fully covers the glass before you detach any of the backing and make an attempt to install it.

Now that this is done, you need to clean the interior of the window with the tint solution and leave the window wet without drying the application.

Next, you will have to wound down the window by up to 2 cm. Start from the top and apply the tinting film while cautiously peeling away the backing film. Keep in mind to peel it off only halfway down before you begin to spray the now exposed adhesive side with tint solution mix.

Place the upper peeled section across the surface of the window. Leave a gap of up to 3mm near the upper edge of the window so that the tint does not get caught and start peeling again as soon as the window is rolled up.

When you start, do it with by laying the top 3 to 4 cm of tinting film against the window and with the help of the squeegee to get rid of any air bubbles out the film so that it lies flatly and smoothly against the surface of the glass. Make sure that you use the squeegee in a downward motion.

Allow the upper section to dry off slightly before you go ahead and apply the remainder of the tint. This is important to ensure that the tint fixes properly in one place. When it dries off, take out the rest of the backing film and install the remaining tint against the glass surface.

It will be a good idea to tuck away the lower edge of the film down into the lower surface of the window. Pull away the rubber trim from the window surface before you use the squeegee at the bottom edge to flatten the film installation on the window surface.And there you have it, the entire process to pull it off flawlessly. You can compare the application of window tints with that of vehicle wraps in market harborough as the process is more or less the same with few exceptions of course.

LEAVE A REPLY

Please enter your comment!
Please enter your name here